Questions & Answers for: Buick Skylark how to remove the coil

Question about 1992 Skylark

5 Answers

...a know working car, if this does not solve your problem the crankshaft sensor is the next stop, To remove this you need to jack up the passenger side of the car and remove the front wheel, then ...

Ad

Question about 1997 Skylark

1 Answer

96 buick skylark 2.4L Engine runs but misfires, multiple cylinders Remove the cover on top of the engine. It has fouth 10mm bolts that hold it on. This car has individual ignition coils for each ...

Ad

...remove the coil harness stuff out of the way so you can remove the wavy type washer. I think you then have to compress the lock plate on the shaft to remove the snap ring, get the retaining ring out ...

...remove the screws holding the coil pack. Also, I'd suggest that you replace the boots and porcelin insulators while you're doing this. Just to make sure that this is truely the problem, you could buy ...

96 skylark, 2.4 quad 4, no spark, when I removed the coil assy. it grounded out and sparked from the coils, fan came on, but it has 12.5 volts from the casing to ground when not bolted down, I know ...

...work. . try the rotor under the distributer cap, remove cap , remove rotor cap and replace, also note if it has black sooty marks on center cap known for fouling. bad coil or eledtronic control ...

Question about 1997 Skylark

1 Answer

...REMOVE TOP IGNITION COIL COVER ON TOP OF THE ENGINE CYLINDER HEAD.YOU HAVE 4 SCREWS HOLDING THE TOP IGNITION COIL COVER ON.IF YOU HAVE THE 3.1L ENGINE YOU NEED TO REMOVE THE WHOLE IGNITION COIL ...

Question about 1997 Skylark

1 Answer

...radiator what tools will i need It depends on the car and engine but in general, you have to remove any shroud that may be around the fan. If it has electric fans you have to remove them. ...

Question about 1986 Skylark

1 Answer

1986 buick skylark not firing Car just died driving and wont start fuses and relays good not getting spark to plugs I have owned several older GM products, and have found that (as with any older car) ...

Question about 1997 Skylark

2 Answers

...coil needs replaced Here's a link on how to replace your heater core.When comparing old and new heater core,make sure the outlets are position in the same direction so the hose that are attached ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...