Questions & Answers for: Buick Park Avenue how to remove the coil

Question about 1991 Park Avenue

2 Answers

engine will not start No spark to the spark plugs. car is fueled and the fuel pumb is working. engine started to run rough at low speeds, but with high rpms would run smooth pulled off on an off ramp ...

Ad

...pack and the problem went away. Since I have 3 coil packs is it possible the other two are bad? It sounds like you have a altinator or air con pully problem.Remove the belt and turn by hand to

Ad

...coil pac. remove the 2 5mm screws holding down the 3 coils and then unscrew the wiring harness bolt in the center of the connector ? the module will lift up ? cant remember if there are any hold down ...

Question about 1997 Park Avenue

1 Answer

...coil(s) are bad remove the two small screws at the ends of the coil. They hold the coil down. Pick the coil straight up, pulling the contacts out of the ignition module. Set the new coil in place and ...

Question about 1991 Park Avenue

1 Answer

still running rough after plugs and wires. Coil pac isnt putting spark to the number 6 wire.can pull wire of coil !!!! and no change on the way it runs.replace coil pac, i assume??? Wires that plug ...

...remove all three coil pack, two small screw's to each coil pack, disconnect harness to ICM will have about 26 small wires on the connector, connector will have a small bolt, in center of harness ...

...remove the coil paks, the electrical connector in front (has bolt holding it in) and I remember one bolt holding the module to the aluminum bracket. Again, to be sure you can switch coil paks around ...

...coil(s) Remove the coil(s) from the ignition control module To Install: Install the coil(s) to the ignition module Install the coil fasteners Torque to 40 in-lbs (4.5 Nm) Connect the spark plug wires ...

Question about 1991 Park Avenue

1 Answer

remove the plug wires.Now the coils are all paired so you need to set your multimeter to read ohms.MEASURE THE RESISTANE ACROSS EACH SET OF COILS.They should all read within 1000 ohms of each other.If

Question about 1994 Park Avenue

1 Answer

...has no spark if so remove coil from module and test the power supply to coil and with a logic probe test the trigger side if blinking with no spark your coil is bad. not blinking replace

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...