Questions & Answers for: Mazda how to remove the coil

Question about 1988 B2200

5 Answers

...coil btw you don't need to remove the coils on these trucks they last forever, so replace the dist cap with one from a junk yard with a coil in it and I bet you will run fine, tune ups on an ...

Ad

Question about 2003 Tribute

2 Answers

...coil. There will be 3 coils mounted on each side of the engine. They are located under the coils. You may have to remove the intake manifold to get to the rear plugs. Big job, may want to consider ...

Ad

...Removal & Installation Before servicing the vehicle, refer to the precautions section. Remove the battery cover. Disconnect the negative battery cable. Remove the plug hole plate by ...

Question about 2002 Tribute

1 Answer

...remove the plastic cover. Since there is a good bit of work involved removing the manifold, I would suggest that you go ahead and replace all of the sparkplugs and consider replacing the coil for the ...

...Remove coil retaining scre 2. Pull upward on the coil to remove. 3. Remove spark plug (using a spark plug socket). 4. Properly gap new spark plug (if applicable). 5. Apply sprark plug anti-seize ...

...coil packs for each cylinder, simply remove each coil pack hold down bolt and remove coil, plugs are underneth coil packs, you will need a long extension and a 5/8 spark plug socket to remove

Question about 2003 Tribute

1 Answer

wheres the spark plugs on my 03 mazda tribute v6 They are under the ignition coils on each side of the engine. The left bank (front of engine compartment)can be relaced by removing the plastic cover ...

remove it to see if condensation You're vehicle does not have a Distributor cap. It has electronically controlled coil/coils, individual to each cylinder. All new car's now use Multipack or individual

Question about 1998 626

1 Answer

...to install coil pack 2.5 V6 Remove the distributor cap and rotor arm. There are a couple of screws holding the ignitor module in.. remove this, and the coil pack lifts out. replace in reverse

Question about 1998 626

1 Answer

and mark where they go for future reference, unplug the coil pack electrical connector and then remove the retaining screws that hold the coil pack to the engine. You never say engine type, V6 or 4Cyl

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 Mazda 6
2004 Mazda 6

738 Questions

2000 Mazda MPV
2000 Mazda MPV

692 Questions

1999 Mazda 626
1999 Mazda 626

544 Questions

2001 Mazda Tribute
2001 Mazda Tribute

609 Questions

2002 Mazda Tribute
2002 Mazda Tribute

615 Questions

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...