Questions & Answers for: GMC how to remove the coil

...remove the coil on a 2000 GMC safari van what bolts hold the coil on? The coil on this model is mounted on the manifold and is sandwiched between a couple bolt nut combos and you need to remove them ...

Ad

remove distributor cap and inspect the inside of the cap and the rotor for obvious signs of wear or damage. Check for spark at the coil wire by removing the coil wire from the center of the distibutor

Ad

Question about 2002 Envoy

1 Answer

Remove the 2 screws on the first cylinder and pull up carefully on the coil. When coil is removed, then you can access your plugs. AC Delco 41-103's are the best, these engines love these plugs. Other

...cause damage. Regards, netvan SPARK PLUGS ON TOP VALVE COVER IN CYLINDER HEAD UNDER IGNITIONS COILS.YOU HAVE TO REMOVE EACH COIL AND ITS BOOTS ON TOP EACH SPARK PLUG.YOU NEED LONG SPARK PLUG

Remove one coil and use either a spark tester or a test light. If there is spark the coil is good. If there is no spark swap that coil with another. If the swapped coil fires than you know the circuit

...remove a pick-up coil from dist Not sure about yours, but on a lot of them you have to partially dissemble the distributor.  Not that hard, just drive out the roll pin on the bottom gear with a ...

Question about 1990 Sierra

1 Answer

remove the ignition coil. The amount and type of bolts vary depending on the part number for the Corvette ignition coil. You may also need to remove the ignition coil arc seal. 6 Clean the distributor

Question about 1991 Suburban

2 Answers

remove the four screws that hold coil in place. there are three wires 1 red and 1 white these have a double spade connector on them remove with needle nose pliers the third has eyelet that screws down

...the ducting to give you more room. When it's off, you now can see all 6 coils. Remove the electrical connector then remove the screw that holds the coil in place. After that, just pull the coil

...remove vacuum tube lift cover away and the third coil pack from front is number 3 the coil and is held down with a 10 mm bolt the following link shows where and how to get there and repair / replace ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 GMC Envoy
2004 GMC Envoy

2,225 Questions

2000 GMC Jimmy
2000 GMC Jimmy

1,363 Questions

2003 GMC Envoy
2003 GMC Envoy

1,368 Questions

2002 GMC Envoy
2002 GMC Envoy

1,418 Questions

1997 GMC Jimmy
1997 GMC Jimmy

1,123 Questions

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...