Questions & Answers for: BMW how to remove the coil

Car rides rough. Decoder tool states that the Ignition Cylinder f How do you replace the ignition coil on a BMW X-5 2001 3.0? remove engine covers and you will then see the coils"Coil-on Plug system"

...Remove ignition coil by pulling straight up Use the necessary tools to remove the spark plugs There are six plugs, and the factory plugs that come with the car are most likely the NGK BKR6EQUP (laser ...

...coil. You can now remove the spark plugs. The spark plugs are not gappable. Install them as they come out of the box. Replace the rubber connector boots at the same time, these wear out and can cause ...

...remove the gray trim covers on the left and right banks by pulling straight up.You will find individual coils in each cylinder. Disconnect the connector of the coil and pull the coil straight up.The ...

remove the #1 coil (2 bolts per coil) after removing the harness from coil #1. Pull coil directly up and remove it. Now using a ratchet 6" extension and sparkplug socket remove the old plug. Check gap

...remove the ignition coils up and out of the spark plug holes on the two far rear spark plugs(#4 right side and #8 left side) because the clearance between the tops of those coils and the body of the ...

...remove the two bolts that hold in the coil that sits over the spark plug (geez, this really is this easy): Unplug the coil by moving the metal clip that holds the plug in up all the way and then ...

Remove coil and inspect coil housing for hairline cracks or leaking casting material . A leaky ignition coil may indicate a faulty engine control module (ECM). Check ECM before installing a new coil.&

...the coils on a 2002 bmw 330i need to change the engine coils on a 2002 bmw 330i need to remove the top plastic cover on top of engine and now you can see the coil remove bolts and disconect the ...

coil. The rear coils are hard to remove and hit the edges of engine compartment insulation and sometimes the fuel and a/c lines. Those can be pushed slightly out of the way to allow coil to be removed