bowl. Remove the screw then replace it after the fuel drains. Any water in the gas? Remove the water trap bowl at the bottom of the petcock, (gas valve). Any water or trash in the bowl? Drain a cup of
Question about 2004 Shadow 400
bowl. Remove the screw then replace it after the fuel drains. Turn the gas back on and wait a minute for the carb to fill with gas. If the bike doesn't start and run properly then shut off the gas and
bowl. Remove the screw then replace it after the fuel drains. Remove the water trap bowl at the bottom of the petcock, (gas valve). Is there any water or trash in the bowl? Drain a cup of gas from the
...bowl. Remove the screw/plug then replace it after the fuel drains. Remove the carburetor from the engine. Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts ...
...remove the float bowl and replace the gasket. If it is overflowing remove the float bowl, pull out the float hinge pin, remove float and float valve. Clean the valve and inspect the valve for excess ...
...remove the float bowl fastener. This is the main jet 3) carefully remove the float bowl, the rubber o-ring/gasket will not be able to be used if it is removed, you WILL have to replace it 4) using a ...
...remove the float bowl fastener. This is the main jet 3) carefully remove the float bowl, the rubber o-ring/gasket will not be able to be used if it is removed, you WILL have to replace it 4) using a ...
Question about Karcher G2400HH-R Pressure Washer
...bowl. 2. Remove float bowl nut and bowl and purge water. Spray carb with carb cleaner while float bowl is removed. Paying particular attention to the float bowl nut thread area (throat) 3. Drain Oil. ...
Question about 1985 CBX
...remove the 16 float bowl screws with the carbs upside down. To remove the screws take a #2 phillips screwdriver and hammer and tap each screw with the screwdriver in place with the hammer. When ...
wont start no ignition put new plug in and fuel filter Flush gas tank, fill with fresh gas and Stabil. Replace air filter. Remove bowl from carb clean bowl and holes in bowl screw.
Usually answered in minutes!
188 Questions
186 Questions
195 Questions
148 Questions
151 Questions