Questions & Answers for: Pontiac Montana remove battery cover

battery--then remove the negative battery terminal. Scratch the terminal over the battery post--lots of sparks (everything turned off) mean something is shorting to ground. Remove the alternator heavy

...BATTERY CABLE.REMOVE THE RADIATOR AIR BAFFLE ASSEMBLY.REMOVE THE ELECTRICAL CONNECTIONS.REMOVE TORQUE CONVERTER COVER.THEN REMOVE STARTER.PUT EVERYTHING BACK VISA VERSA.TORQUE STARTER BOLTS 35 FT

battery then jack up vehicle and support it with stands.the starter is on the front of the engine,there are two bolts that hold the starter up.you will need a 15mm socket to remove the bolts. you will

...battery. It is a long triangle shaped piece. Second remove bolt that holds the electrical fuses that sit on top of the battery. It is just one screw that holds this. It is located just below, toward ...

Remove or disconnect the following: The negative battery cable The windshield wiper system module cover (if equipped) The fuel injector sight shield (if equipped) Rotate and secure the engine forward.

Remove or disconnect the following: Negative battery cable Wiper system module cover Fuel injector sight shield Rotate the engine forward. Remove or disconnect the following: NOTEDo not disconnect the

...the battery. Remove the battery cables. Swap batteries. Reverse above steps. If you have any comments please feel free to leave them here. Hope this helps and thank you for using FixYa. ...

...battery cable. Raise and support vehicle. Remove flywheel cover (s). Disconnect starter solenoid wiring. Remove starter mounting bolts. Remove shims and note arrangement for reassembly (if equipped). ...

...Battery Negative Cable Disconnection and Connection. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information. Remove the starter motor BAT terminal nut ...