Questions & Answers for: Buick LeSabre remove battery cover

...battery cable. Remove the serpentine drive belt from the alternator, as outlined in Section 1 of this manual. Detach the electrical connections from the alternator. Unfasten the alternator mounting ...

...battery cable. SOLENOID REPLACEMENT Remove the starter, as outlined earlier in this section. Remove the screw from the field strap at the rear of the starter. Remove the 2 bolts holding the solenoid ...

battery cable. Raise and support the vehicle safely. If necessary for access, remove the splash shield. If equipped, unfasten the flywheel inspection cover bolts and remove the cover. Label and detach

...battery. Remove the 3 10mm bolts holding on the cover. There should be 2 14 or 15mm bolts going up thru the starter, into the block. Disconnect the wiring going to the starter. Some starters had a ...

battery cable. Drain the cooling system into a clean container for reuse. Remove or disconnect the following: Heater hoses from the heater core Right sound insulatorAll necessary electrical connectors

...battery, remove vent hoses from battery. Pull battery out. When reconnecting new battery, connect red cable first. Make sure there isn't any corrosion on bolts or cable. There is nothing under the ...

...battery cable. Remove the front cover from the engine. Remove the oil filter adapter, pressure regulator valve and spring. Remove the oil pump cover-to-front cover screws and the cover. Remove the ...

...remove starter disconnect battery first. safely lift and support vehicle. remove lower coverand flywheel cover. remove cable and wires at starter. becareful of other wires and sensors during removal, ...

...Remove the torque converter cover. Disconnect the battery positive cable from the starter. Disconnect the wire from the solenoid S terminal on the starter. Remove the 2 starter motor mounting bolts. ...

Battery Negative Cable Disconnection and Connection in Engine Electrical. Remove the steering wheel. Refer to Steering Wheel Replacement . Remove the gap hider. Refer to Instrument Cluster Replacement