Questions & Answers for: remove back door panel gmc

back passanger door take out top scews and fold down stick hand in and pull the rod down this should open door then finish removing panel you should see the problem then For my 2003 Safari, there were

remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them.

...remove the interior panel on the door which will be fun and take some time. Once you have it removed you should be able to manually operate the linkage and get it opened. I would be ready to locate a ...

rod connecting to the interior handle (replace this handle if you need). Otherwise pull back the weather seal and remove the bolts securing the outer door handle and disconnect the rod from that one..

...back remove the panels and find the actuator(s), when you find them check for any linkages the may have fallen off. Gm uses little clips that get brittle and break. if it is a clip reinstall rod with ...

...equiped i mean IF"""" it should be inside back door left or right in side quarter panel take of removeable panel then you should gain getting at it! if equiped! How about in a van it's a rally stx ...

...back door from inside and release/open door These handles break all the time after alot of use,It will break inside of door where the rod hooks up.Remove inner panel as far as possible and reach in ...

...back latch is electric release. It's a fuse under the dash. I forget which one, but it's not the door lock fuse. Just pull everyone and you'll find it. Sounds like the actuator is working, but one of ...

...remove the upholstery panel- then you'll see the actuator and rod assembly- the outside end of the rod is dangling- take it out and use it to "fish" for the lever arm hole to pull the lever back ...

remove the rear door panels and check wiring to switches and actuator, then follow wiring from inside the rear hatch to where in goes through the body.  the wiring most times breaks at that point