Questions & Answers for: remove 4wd drive shaft

...4wd, just want to no can i remove the cv shaft by removing the disc and pulling out that way or do i have to go into the transfer case, ihave only removed the wheel at this stage/regards terry HOW TO ...

Ad

Question about 1995 B-Series

2 Answers

...4wd selected have had this happen on both drive/prop shafts and especially! on steering wheel shaft uj s and also giving stiff turning of steering wheel at a certain point also steering fails to self ...

Ad

Question about 1995 B-Series

1 Answer

4wd drive is selected. Mobil synthetic 75w 80 is in the front diff. I did run the vehicle on the lift in 4wd. The actuator is trying to engage. I removed the right side axle housing and found the shim

...4wd shaft. You have to start at the outer hub screw the screws around it remove the the auto hud then sirclip on the drive. The four bolts have to be removed from the balljoint. Push the shaft fully ...

...Remove and discard small "U" bolts on yoke Slide drive shaft up spline end to dislodge drive shaft from yoke. You can either "beat" U join out of shaft, but better to bring to auto parts store that ...

is sold as 2WD - rear wheel drive), you can't turn them off. The Granny with 4WD has a All Time 4WD. The only way to turn it off is to remove the drive shaft and close the hole in the gearbox...smile.

...case in the 4WD HI mode and remove the rear drive shaft from the vehicle.* You may need to PLUG the output shaft to retain the proper transaxle fluid level if the rear drive shaft is a slip yolk

...rear wheels or remove the rear drive shaft and lock in the 4wd to derive the front axle you may need to discuss the proposed changes with an accredited transmission shop to get it properly ...

...4wd have tow dolly want to put front wheels on dolly any problems with doing that thank you This is what I would do; Drive it on to dolly. Secure the front tires to the dolly have it ready to tow. Go ...

...drive shaft and diff on my 94 aerostar and drive on rear drive only just remove the front drive shaft at the flange bolts if it is an all wheel drive vehicle engage the 4wd to lock up the center ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...