Questions & Answers for: release scanner

...scanner is stuck in scan, laser will not release unit will not release the scan laser, will not power down nor read. don't want it to crash and lose data. It will either be the trigger or the scanner ...

release frequencies by pushing and releasing the MANUAL key and then pushing the L/OUT key and holding it in for about 2 seconds. The scanner should beep to confirm that the lockout has been released.

...release the port after reading the scanned over RDP? If your scanner has a twain driver, you could install drivers on the device and use Elusiva Remote Scanner from ...

scanner's display, release the CLEAR key. NOTE: You must release the RESET button before releasing the CLEAR key. Also note that this procedure may not be necessary. Programming a new frequency into a

...-is this a new scanner? is this the first time you are trying to scan? if you answer yes to any of this questions, please check underneath the scanner, find the latch to release the scanning

...release the scanner lock switch and turn the power off and back on..Please help what is the scanner lock switch and where is it on the Printer?? Issue: ERROR LCD: Release the scanner lock switch and ...

...the I/F cable try this 1. at the back of the scanner there is lock try to release that one (slide to unlock) 2. uninsall the system and re-install again 3. check the usb port of your computer ...

...off the PDT 3100 by pressing the "PWR" button. 2 Press and hold the "A," "B" and "D" buttons. 3 Press and release the "PWR" button. 4 Release the "A," "B" and "D" buttons. The scanner will

...scanner. I slid the lock button to the unlock position. When I try to scan, I get the following error: "Release the lock switch, detach USB cable and reconnect." I released the lock switch ...

...scanner, lower the jam access cover and release the two scissor hinges. Disconnect two connectors and release safety cable (be careful at this point because scanner is no longer secured). Disconnect ...