Questions & Answers for: relearn key

...relearn you need the MASTER KEY and it can not have RPO CODE (OPTION CODE) (Z49) this procedure should only nedd to be perfomed when 1 NEW KEY (PK3) 2 BCM (BODY CONTRO MODULE) 3 PCM (POWER CONTROL ...

...sensor. try relearning the key fob,turn the key on,leave it for ten minutes,and turn it off,and right back on,do this three times total,and a total of thirty minutes,this should relearn the key

key II anti theft system turn the igntion on, don't start, let it set for ten minutes Turn it off for 5 seconds then try to start it. If it lost memory for some reason and doesn't start . then

...key relearn process. 1. Perform a security system relearn. 2. Let the vehicle sit for more than 10 minutes with the key off. 3. Attempt to start the engine, leave the key in the run position ...

engine willnot start willnot read key i had it reprogram twice Try this,,,,relearn steps are crank it ,leave the key on 5 min,turn key off and repeat. sometimes takes 2 or 3 times to relearn

...key by using the relearn process. In order for the vehicle to start, the BCM (as well as the Passkey module in other vehicles) must identify the resistor pellet in the key, then the BCM sends a ...

...On the WEB Images for vauxhall astra immobiliser car wiring ... there is a relearn for ur new key ask a dealer about sequence doesnt cost any thing for relearn unless their is other programs to ...

...relearn procedure. With a master passkey III key, turn ON the ignition, with the engine OFF. Observe the STARTING DISABLED DUE TO THEFT message on the drivers information center (DIC), after ...

...relearn the key information and/or the passwords on the next ignition switch transition from OFF to ON. Turn OFF the ignition and wait 5 seconds. With a master Passkey III key, start the vehicle. The ...

...relearn Key fob programming in Chevy Impala 2010 as it is not letting me enter the Remote key learning Active mode I am trying to program my new keyless remote for my 2010 Chevy Impala. I am to press ...