Questions & Answers for: Ford Thunderbird relay switch

Question about 1992 Thunderbird

2 Answers

...if anything has been done under the dash. check the relays. sometimes you can find a matching relay on another component. switch the relay and see if your still having a headlight

Ad

Question about 1991 Thunderbird

1 Answer

...relay switch. I have a 1991 Ford Thunderbird and my light have a mind of their own. They flick on and off when ever they feel like it which is no good in the dark. I beleive it to be the relay switch ...

Ad

Question about 1988 Thunderbird

1 Answer

...relay in the fuse box.are you getting power into and out of the reset switch? from there it goes to the fuel pump. if power is getting to the fuel pump and it has a good ground, the the pump is

...relay and the reset switch (inertia) on a 1988 thunderbird turbo coupe Relay is inside the ICM (Integrated Control Module) right ahead of the right shock tower. The inertia switch should be in the ...

Question about 1988 Thunderbird

1 Answer

relay, is a switch to ground, at the bottom of the intake manifold. If the switch was changed out for a temp sensor it would stay on until the engine cooled. If the wire is chaffed and touching ground

Question about 1988 Thunderbird

1 Answer

...switch. check flasher relay,but most likely the fault is the turn signal switch . ---------- The turn signal / hazard flasher relay is located behind the dash, right of the steering column. -------- ...

Question about 1992 Thunderbird

1 Answer

...relay and inertia switch both good fuse good Code 542 indicates one of the following conditions:Engine Starts: · Fuel Pump secondary circuit shorted to power · Fuel pump relay ...

...relay switch on a 1994 ford thunderbird. I found the inertion cutoff switch in the trunk but not the relay switch. thank you mind was in the passenger side kick panel under the dash you will find the ...

Question about 1994 Thunderbird

1 Answer

...switch and should click the relay on to pass battery voltage to the starter. If power there, the relay may need replacing. If no power, work back to the neutral safety switch. Pull the connector off ...

relay or fuses ????? I assume everything else works so start with the schematics and determine which fuse(s) and circuit(s) these power windows are on. Find the fuses. If these are OK, check wires for

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...