Questions & Answers for: Ford Explorer relay switch

relay on 1999 ford explorer does not lock with switch does open with switch Found this answer in anotherr forum and works for me.Power Door Lock Relay Location Aux Relay Box #4 is in the rear driver's

...relay switch wiring. Remove the protective cover. Disconnect the push-on electrical connector. Remove the nuts. Remove the cable. Remove the starter motor solenoid relay switch (11450). Remove the ...

...switch, starter relay 6*=20A Transfer case relay 7*= NOT USED 8*=20A Auto Ride Control Switch/on off switch 9*=40A Auto Ride Control relay 10*=30A PCM power relay mini fuses 1=10A A/C relay 2=20A Aux ...

switch. What could be wrong? park relay may be shorted. find relay in engine compartment relay box. Pull relay out--lights should go out. Put back in, does relay click? If no and lights come on again,

Switch, Starter Relay 6 20A** Transfer Case Relay 7 - Not Used 8 20A** Air Suspension 9 40A** Air Suspension 10 30A** PCM Power Relay 1 10A* A/C Relay 2 30A* Heated Seats 3 30A* Heated Backlight 4 15A

...relay, the inertia switch and fuel pump all checked ok, and fuel pump is working with direct 12 volt source to fuel pump.Then problem relates to computer.The computer (power control module, PCM) is ...

Relay?? pull switch if no power back track to find open if power switch is bad the a/c relay runs the compressor a/c fuse powers relay fuse is powered by the ecm , ecm gets command from control switch

...switch grounds the relay, kind of like the horn relay. The relay may have lost a connection -- power in wire or ground wire to the on/off switch. Or the power wire into the relay or out to the lights ...

...switch, starter relay 6*=20A Transfer case relay 7*= NOT USED 8*=20A Auto Ride Control Switch/on off switch 9*=40A Auto Ride Control relay 10*=30A PCM power relay mini fuses 1=10A A/C relay 2=20A Aux ...

...relay may be faulty. if no then horn switch could be faulty. you can check switched voltage also at horn relay switched contact when relay plugged in. To see if relay is doing what it is meant to ...