...cap and rotor Not sure about your engine size so please pick your model: 2.5L Engine Before servicing the vehicle, refer to the Precautions section. Remove or disconnect the following: Bolt holding ...
...refer to is only the upper cap. That portion is basically a breather area and the tiny hole is a breather hole. To remove the cap to add fluid is easy. The larger gray colored cap below the small one ...
...over the screw just take a flathead screwdriver and pop the cap off and tighten the screw The cap referred to above is in reference to the black plastic cover on the outermost part of the handle ...
...cap trigger these codes too? codes p 0440 through to p 0459 all refer to the EVAP system. code p 0455 refers to EVAP system very large leak which refers to a loose or missing gas cap manifold leaks ...
Question about 2007 Corolla
...cap and refer to the position of the rotor arm. It is pointing to number 1 plug lead (number 1 cylinder). You can start from that reference and hook up No.1 plug lead. Then, as your rotor arm turns ...
Question about 2007 Corolla
...gas cap and now is showing a 0442 code. do I need to drive it more so it will activate code p0442 refers to evaporative emission (EVAP) system--small leak detected.===causes---hose connections ...
Question about 2007 Corolla
...Pilot Evap code P1456 Changed gas cap from honda and still Vehicle shuts off on ocasion code p1456 refers to evaporative emission (EVAP) canister purge system(fuel tank system) -leak ...
Question about 2009 Sable 4WD
...Sable and got P0442 diagnostic code so how bad is diagnostic and how costly to fix? code p0442 refers to evaporative emission system(EVAP)--small leak detected==causes-- hose
Question about 2009 Sable 4WD
...Originally, only had one code P0442, after the unsuccessful removal of severalevap code p 0442 refers to evaporative emission(EVAP) system---small leak detected====causes--hose ...
Question about 2009 Sable 4WD
...cap tie plate. Refer to Adhesives, Fluids, Lubricants, and Sealers. Note: The complete installation procedure should not take longer than 10?minutes. Install the 4?lower crankshaft bearings?(3) and ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions