Questions & Answers for: reassemble impact gun

Ad

...impact gun.The reason is you have to remove the cv axle nut and axle out of the way before removing the bearing and hub.The axle nut requires a couple hundred foot pounds to remove.The procedure ...

Ad

...inside of the gun with solvent or brake cleaner, reassemble and it should work fine. If the plates need replaced then you should be able to order them from a tool supplier,and they are not that

Ad

Question about 1/2" Air Impact Wrench

1 Answer

...impact gun i own a craftsman 1/2' impact gun model 875198641. the hammer pin broke. i replaced the pin and reassembled the gun. what lube oil is used in the hammer housing and how much is required. ...

Question about 1/2" Air Impact Wrench

2 Answers

inner parts of the impact, lubricate with W-D 40, and reassemble. 4. I'm all out of ideas.. If that didn't fix it, I'd go get a new one. Best of luck, --W/D-- Have you added any air tool oil in awhile

gun The air motor is probably shot. Turn the socket a few revolutions by hand, and see if it frees up and starts working. A couple of firm raps on the workbench might help. Otherwise take it apart and

...impact gun. This will allow the pulley to lower enough to remove the front part of the belt. If the pulley is stuck, use a backside pulley puller to remove the stack pulley. Any other kind of puller ...

...impact socket).Dislodge the ball joint from the knuckle(a large punch rapped on the sides of the knuckle hole will help to break it loose).Lower the control arm and pull the ...

Question about 2135Ti Air Impact Wrench

1 Answer

...IMPACT TAKING OFF TIRES TRIGGER STUCK IN ON POSITION BUT STOPPED WORKING, DISCONNECTED AIR, PULLED OUT TRIGGER WITH NEEDLE NOSE PLIERS. CONNECTED AIR AND GUN WORKED THEN STOPPED WITH TRIGGER STUCK ...

Question about 440 Impact Airless Paint Sprayer 440i 805-015

1 Answer

...brush or cu-tip to clean the inside of the barrel. Blow though it and see if air passes easily. reassemble and run as you normally do. Be certain the top is attached to the paint reserve tightly ...

Question about 440 Impact Airless Paint Sprayer 440i 805-015

1 Answer

...reassemble.. Call around first to see if you can get parts. You may be better off getting another unit from a salvage yard. You have to remove the hoses, the steering linkage and the pitman arm. And ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...