Questions & Answers for: reasons cylinder firing

Question about 2004 WR 250 F

1 Answer

some one help? Sounds like your not firing on all cylinders . If you are getting gas in the exhaust then the cylinder would not be firing for some reason. That would also cause top speed to be limited

Ad

...firing on 2 cylinders My Brother-in-law has A 1993 Chevy Cavalier 2.2, cylinder That I am working on for him. it started running really bad while he was driving it. When he brought it over I checked ...

Ad

cylinder not firing is. It could be something as simple as a bad spark plug, or a bad plug wire, or a clogged up or bad fuel injector. Or something really expensive as a blown head gasket or a leaking

firing order for the 3.8L VIN K and 3.8L VIN 1 engines is 1-6-5-4-3-2. Starting at the front of the engine, cylinders in the left bank are numbered 1,3,5 and cylinders in the right bank are numbered 2

Question about 1998 S70

1 Answer

...firing order, but could change the relative placement of the plug towers in relation to the engine. For this reason, it is imperative that you label all wires before disconnecting any of them. Also, ...

...firing order for this truck, due to it has 8 ignition coil pack's and each cylinder has it's own coil pack that sits over each cylinder (spark plug), remove 8mm bolt on each coil pack and slide coil ...

Question about 2003 Expedition

1 Answer

firing p3o3 changer ecu after few mins mis fires is my crank position sensor not reading the third cylinder for some reason i did a motor swap ran new motor 3 or 4 hours had miss shift problem occured

Question about 1998 Rodeo

2 Answers

...cylinder and #2 being driver's front... what country? spark reasons or cam reasons, we cant guess that. state it. spark systems vary by engine and country used. 100% usa answers on USA forum the 3.2L ...

...firing is form combustion fire coming back past an inlet valve into the inlet manifold It is from valves held open, weak valve springs at high revs, hot spots in the cylinder and head , timing, HT ...

Question about 1998 Rodeo

2 Answers

...although the firing order is 1-3-4-2. etc. The wires on the distributor cap has to reflect this. as the rotor button passes each plug wire must be in the proper firing order to the correct

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66947 Answers

Are you a Motorcycles Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...