signal lights and wiper blades stop working i have a 2006 dodge magnum and the wiper blades and signal light wont come on. these are controlled by the BCM (body control module) the dealer can test it ...
how do you remove/replace rear wiper blade? you can www.napa.com they had instructions on wiper blade replacements
fuse box? there is one fuse box under the hood on the drivers side and the other fuse box is in the rear of the car under the trunk liner where the battery is
Front Windshield wipers do not turn on I have a 2006 dodge magnum and just replaced the fuse and the front windshield wiper motor and it still does not work, what else could be wrong ? better ...
...wiper blade from a 2006 dodge magnum to replace with new blades Where the pivot point is take a small screw driver & release the clip slide blade off. Most auto stores will replace the blades for ...
I'm trying to install anco winter blades and can't seem to get them to click on the wiper arm . Make sure you are sliding them all the way back and they should clip and lock, some of these anco blades
...rear wiper. Park the vehicle in a dry area, try pressing the washer, open bonnet and have a look to see if there is any water on the ground or in engine bay, if there is then one of the hoses that go ...
The windshield wipers on my 2007 dodge magnum will not turn off even if the car is not running unless I take fuse out, how can I possibly get the problem resolved I switched the two relays under the ...
hey my 2006 dodge magunm 3.5l high output all of a sudden the windshield wipers will not turn off by using the signal indicator/wiper control or by shutting the car offf...i had a guy look at it and ...
rear wiper gets snagged on the fixture of the cyclopse brake light. My 2005 Dodge Magnum was rear-ended awhile ago (and repaired), and then shortly threafter I had the Valvoline-Quicky-Oil-Change Team
Usually answered in minutes!
676 Questions
300 Questions
74 Questions
20 Questions
26 Questions