remove and replace rear struts have heard need a compressor but my ? is why I need one when there is no big spring on them . I t has leaf spring on it . then they are not struts they are just regular ...
Just did Front Struts on 04 Alero will not doing the rear struts for awhile affect the durability / performance of the new struts?? no it will not affect most of the time the front struts will go ...
Question about 1996 Cutlass Supreme Coupe
...rear wheels. Then look at where the strut mounts to the wheel, there are two bolts holding it on the wheel assembly; remove those (you may need to jack ut the suspension to remove the bolts). Now ...
...will be MacPherson struts, a shock absorber surrounded by a coil spring looking set-up. FOR THE REAR: If you have front wheel drive and you have Electronic Ride Control (ERC), then the rear ...
...strut to change spring and mount), or you can have them do the whole thing. rear shocks are bad. the way you can tell for sure is to go out to the car and push down on each rear side of the car real ...
it still sets to low. How can I raise the rear of car. are there aftermarket parts to do this? It is not the strut that determines the ride height, but rather the spring. The struts are only a dampner
Need to know what kind of rear shocks and struts to purchase I have KYB's on my 2000 Intrigue, they are not break the bank expensive and it handles great. Auto zone has Gabriel front struts for $62.99
strut on the rear even though it doesn't have a coil spring wrapped around it. it bolts to the rear spindle and goes through the rear of the body. the car will need to be re-aligned if you replace
how do I chnage the front and rear shocks in a 2001 4.0 How do I cange the shocks in a 2001 aurora 4.0? How hard is it to change the shocks. No rust mounts appear to be good. The shocks in the rear ...
Question about 1993 Cutlass Supreme
...strut bolt Rear rubber dampener Problems!!! You should be replacing the rubber bits as well instead of using the old bits. IT the mount is in rubber that is pressed into the hole at the bottom of the ...
Usually answered in minutes!
1,478 Questions
1,272 Questions
1,097 Questions
1,065 Questions
988 Questions