Question about Rc Revo Nitro Monster Truck
How do you change the throttle servo on a revo 3.3 Disconnect the servo at the receiver, remove the servo horn and linkage from the servo. Remove the four screws that hold the servo to the chassis. ...
...rc traxxas truck is not turning what do i do? Check servo saver to make sure it has not loosened up. If the servo is not trying to turn at all check the connection at the receiver. If it is okay, you ...
Have a 5#10. Even on full battery the tail wobbles left to right and the heli rotates right continually even when trimmed fully to the left - can you help? REMOVE CONTROL HORNS AND SET SERVOS TO ...
Question about Tamiya 1/10 Rc Hp Off Road Racer Rising Storm Kit
RC transmitter does not have reverse polarity controls. What could be reason? turn your servos around ALL radios have a servo reversing switch for each channel (steering and throttle). You want to set
...rc.com/downloads/data-sheets.html Digital simply refers to the "Pulse Train" that is used to PWM drive the servo, all the other data you need, voltage current etc, are all included on those sites ...
Question about Bls452 Brushless Ep Car Hi-torque Servo 2pack
...rc helicopter, but I'm in the process of building a twin propeller helicopter like the scorpion gunship on the movie " avatar" and I'm trying to figure out how to mix forward ...
Problem with servos burning up Terry, look at my other answers about this, could it be another post by you? Digital and anologue tail servos need selecting on your gyro ;)
Question about Remote Control Rc Helicopter
Have trex 450 v2 , with hobby wing ESC , two rudder servo burn up under two different transmit have you got a digital or analogue servo in the tail. You have to select what type you are using on the ...
...for a nikko rc subaru vintage the one with the servo attached to the circuit board. Most all downloadable rc manuals found here: Manual for RC MODELS NIKKO ' User Guide RC models NIKKO User ...
Question about Remote Control Rc Helicopter
...rc sailboating. When my left gimbal is all out or in, the sail servo stops, but you can hear the servo motor humming. Shouldn't it be off. Is there a adjustment I can make to the tx? ...
Usually answered in minutes!
843 Questions
243 Questions
163 Questions
186 Questions
140 Questions