...raise the presser foot lever release the foot by raising the lever located at the back of the presser foot assembly place a different presser foot on the needle plate so that the bar on the presser ...
...raise the foot ? I would like to top stitch in order to finish the jacket. Any ideas will be appreciated. Thanks much. Jane Are you pulling the presser foot all the way up. Most machines, stop when ...
...raise the presser foot lever even when it's already raised and it won't work at all. Works just fine without the embroidery arm though. My moms does the same. One way we got around it was to hold the ...
...the Zipper Foot around the presser bar from the back, and tighten the presser-bar screw. 3. If the raised edge (zipper or cording) is to the right of the needle, adjust the Zipper Foot by loosening ...
Question about 15218 Mechanical Sewing Machine
...raise the foot, only pushes the horizontal bar to the upper tension system. Can the piece that rides on the top of the lever be adjusted so it engages the lever sooner, thus raising the presser foot ...
...See p. 10 of the manual. The presser foot lifter is on the right side of the leftmost part of the machine, towards the back of the machine. Press up to raise
Question about 15218 Mechanical Sewing Machine
...needle bar and presser foot. I've tried everything, can anybody help? Hmm. Raise the foot with the presser foot lever. You have to raise the foot up to get the fabric under the foot in order to
Question about 15218 Mechanical Sewing Machine
...RAISE the Presser Foot when threading the machine or when removing fabric. When threading or removing the fabric, try raising the needle to its highest point. Raising the presser foot releases the ...
Question about 15218 Mechanical Sewing Machine
...RAISE the presser foot when threading the top. Raising the presser foot releases the tension disks so the thread will seat properly. When the presser foot is raised, you should be able to pull the ...
Question about 15218 Mechanical Sewing Machine
...Foot and raise its Lever. Keep the lever raised and hook the walking foot around the shank / presser bar. Slide the foot up and down until you've lined it up with the hole, so that you can insert the ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions