Questions & Answers for: rachet

...see a spring loaded tensioner,usually right by the pulley you will see a square hole to insert a rachet,pull back and remove the belt.it might be helpful to have a friend to hold the rachet with ...

...lower intake manifold on 92 Bonneville naturally aspirated dont know just tighten with a 3/th drive rachet till it feels right ,once nut locks in then two fingers on end of rachet and a slight nip is ...

How to change serpintine belt on 1997 Dodge Dakota. very easy take a 5/8 socket on rachet on the furthest left pulley. Then pull rachet to driver side the pully wil move enough to remove belt make ...

...tightening specifications 3.3 engine. I need exhaust manifold ft.lb tighten with a 3/*8 drive rachet and that will be enough ,small grunt when pulling on the rachet and you will have the

how to torque transmission pan as tight as you can get it with a rachet and 1 hand close to the rachet head

cant get the belt over the tensioner you should be able to rotate the arm using a rachet-see if there is a 3/8" or 1/2" square cutout on the arm, insert the appropriate rachet head and move it

...you replace a serpentine belt there should be a diagram under the hood for routing and if you use a rachet just the rachet 1/2 inch drive i do believe you can locate the belt tensioner and in the ...

...8-speed cassette Hi,Repacking a Campy 8-speed cassette hub. Have a challenging time getting the rachetting mechanism (dogs and springs on the axle) back into the hub shell even with the ...

craftsman 3/8 ratchet model 875-188020 no power Check the O-rings in the rachet, itf they are leaking then the rachet will not work.

cable clutch keep on snapping rachet plz help The clutch cable causes these problems the cables are plastic lined and bind under pressure inspect where cable enters housing if looks like several paths