Questions & Answers for: pwb order

...If you have the schematic diagram, look for the deflection PWB. The STK392-110 ICs are mounted on 2 heatsinks, in order to remove the parts you will need to unplug the deflection PWB from the

...lcd is not sold separately and, you will need to replace the whole PWB assembly in order to fix this issue.This is actually a pwb(pcb) assembly failure. CLICK HERE TO ORDER YOUR NEW PWB

...white connector in the main PWB assembly is bad or unstable. Or the motor harness between the sator assembly and main PWB assembly is cut (open circuit). * The hall sensor is out of

...white connector in the main PWB assembly is bad or unstable. Or the motor harness between the sator assembly and main PWB assembly is cut (open circuit). * The hall sensor is out of

white connector in the MAIN PWB ASSEMBLY is bad or unstable. ? The MOTOR HARNESS between the STATOR ASSEMBLY and MAIN PWB ASSEMBLY is cut (open circuited). ? The hall sensor is out of order/defective

...circuited). ?_ Repair/replace the damaged WIRE HARNESS ? The Hall Sensor is out of order/defective. ?_ Replace the Motor ? The controller(Main) is out of order/defective. ?_ Replace the PWB

PWB assembly is out of order, Winding in the stator assembly is short circuited. LE Locked motor error. Cause: The connector (3-pin), male,white) in the motor harness is not connected to the connector

...MAIN PWB ASSEMBLY is bad or unstable. â?¢The MOTOR HARNESS between the STATOR ASSEMBLY and MAIN PWB ASSEMBLY is cut (open circuited). â?¢The hall sensor is out of

order for it to turn back on.. can you tell me why this is SYMPTOM: The set Shuts down. May hear a "Pop" when the set is first turned on. SOLUTION: When ever this situation is encountered, first check

error code c1300 If the problem persists, check wiring between PCs UN3, unit PH, and the PWB-A and, if correct, change UN3, PH Unit, or PWB-A, in this order.