Questions & Answers for: pulse 100

Question about Digit-Ox Finger Pulse Oximeter

1 Answer

...pulse oximeter whether it is portable or built in type is 95%-100%. If ***********'s oxygen reading as you have said is 97% definitely it is within the normal range. You can also check and make sure ...

Ad

...pulse. '92 Audi 100. New sensors, rebuilt ecu. Good grounds but still no pulse, no spark. Can anyone tell me how to check a cam position sensor?Could it be possible that I bought a bad part? ...

Ad

my panasonic 1080i tv will flash green for approx 100 pulses then switch to red I have tried leaving the television unplugged for 15 minutes but the same thing happens. I tried counting the pulses and

...pulse rate be over 100 There are many reasons for a high pulse rate. Your pulse rate is the same as your heart rate. A common cause is anxiety. A heart rate over 100 is called sinus tachycardia . ...

...problem is that the pwm controller (l5991,ic) in (pwm2000card), doesn't control the duty cycle of pulses. The d/c is controlled by a NE555 and a lm324 circuitry(fba1001card). I'm looking forward

...pulse rate is anywhere between 60 and 100 beats per minute. Middle age good physical condition 80 beats per minute plus or minus 10 beats per minute is about right. If you're out of shape closer to ...

Question about Thermadyne Inverter Stick/TIG Welder 185 AC/DC

1 Answer

pulse width 60%, peak current 100, background current 30, Hz 1.0 1/8" (.125) - pre-flow .1 sec., hot start 20, amperage 150, Hz 80, balance 20%, post-flow 6.0 sec. For pulse settings - set pulse width

Question about Thermadyne Inverter Stick/TIG Welder 185 AC/DC

1 Answer

60 to 100 beats per minute. The pulse rate may fluctuate and increase with exercise, illness, injury, and emotions. Females ages 12 and older, in general, tend to have faster heart rates than do males

Question about Thermadyne Inverter Stick/TIG Welder 185 AC/DC

1 Answer

...pulse to injector coil..... ? all injectors dead. or just 1. same for spark. toss coin land, noid dead. all noids loss of. NOID signals.! 1; spark 2: lose of CMP or CKP signals (cam or crank ...

Question about Thermadyne Inverter Stick/TIG Welder 185 AC/DC

1 Answer

...rate closer to 40 beats a minute. A normal pulse rate lasts 60 - 100 per minute. You can check it through the devices like heart monitors, defibrillators(dfibrillateur) etc to find out the exact

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Health & Beauty Experts

Rob Hill
Rob Hill

Level 3 Expert

1480 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66963 Answers

ADMIN Eric
ADMIN Eric

Level 3 Expert

39389 Answers

Are you a Health & Beauty Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...