Crankshaft pulley Nissan Pulsar '91 N14 Crankshaft pulley drives two belts and appears to be that two pulleys are joined together. Is the alternator belt pulley a press fit on the water pump pulley or
1996 nissan pulsar hi my fan belt is making noises when i start the car how do i tighten the fan belt get underneath your vehicle and look around at the pulleys and you should see a bolt sticking out ...
...belt as well. Please advise i recently experienced the same issue. it can be your tensioner pulley or your water pump see the belts are connected to the pulleys and sometimes get worn out and ...
Question about 1990 Pulsar
Broke main belt @ 117km. Is this a major problem with this transmission? CVT durability. This car has just broken the main belt. Is this a major problem? to answer your question... yes. belts are ...
...or test I can do? Thanks, Sean yes, chk the crank sensor, mounted @front of engine near the crrank pulley. Make sure it is plugged ...
...Disconnect battery.2. make sure the engine is at top dead center(TDC).3. take belts off.4. Remove pulleys,except for the camshaft pulley..5. Remove timing belt cover.At this point you should see
...is out. i would like some help on how to fix it. take number one spark plug out.turn the main pulley till you can see through the spark plug hole that the piston is at the top of its
and spun it ,what can be done to remedy it there will be 2 bearings, one is replaceble in the front pulley the other will need the a/c compressor to be pulled down to be replaced. just undo the centre
...,WITH ENGINE OFF,GO TO COMPRESSION STROKE AT TOP DEAD CENTER AND YOU WILL SEE MARK ON CRANK PULLEY AND MARK ON TIMING COVER AND THAN YOU CAN REMOVE TIMING COVER AND CRANK PULLEY AND ...
Question about 1988 Pulsar
Where is the timing marks on a 1988 Nissan pulsar nx se 1.6L N13 engine line up the mark on the crankshaft pulley with the mark on the timing cover.
Usually answered in minutes!
331 Questions
95 Questions
65 Questions
52 Questions
21 Questions