Questions & Answers for: Chevrolet Tracker a c pulley

...have come off in that span of time. I would make sure you do not have a worn out idler or tensioner pulley bearing before installing your new belt or reinstalling the original if it is not worn or ...

Can't get A/C belt around pulleys on my 01 Chevy Tracker 2.5 V6 Replacing belts. Got alt belt back on with major difficulties. Got A/C belt off after loosening tension bolt on idler pulley. Now can't ...

Can't get A/C belt around pulleys on my 01 Chevy Tracker 2.5 V6 I just replaced both belts the power steering idler pulley on our 01 tracker/2.5 v6. It still squeals when the ac is turned on. The ...

...2. Using a Serpentine Belt Tensioner Tool or Wrench or Ratchet Tool: Rotate/Move the Tensioner Pulley/Arm away from contact with the belt and towards the area where the belt is not in contact ...

I need an Idler pulley or the pulley that runs air conditioner belt as well as the belt for the power steering OK. If your idler pulley is bad then unbolt it and while you're at it replace the power ...

hi there, what is the name of the motor pulley of a 2002 tracker and Is this pulley pressed fit or attached with bolts? Which pulley? You will have a crankshaft pulley, alternator pulley, power ...

...the belt tensioner located and do i need to remove the fan assembly and shroud.the serpentine belt pulleys are in front of th altenator pulleys so im assuming i will have to partially remove that ...

...the radiator shroud. Use the routing diagram to properly route the new belt around each accessory pulley. Look on the front of the engine between the alternator and the power steering pump and ...

...on the serpentine belt when the vehicle does not have an automatic adjustment? Find tensioner pulley loosen nut on pulley turn adjusting bolt at the back of pulley , re-tighten pulley nut. ...

i have changed all the pulleys except for my A/C pulley on my 2002 chevy tracker 2.0 liter engine. The serpentine belt has been changed at least 8 times over the last 5 years. i changed to pulleys in ...