Question about Pro 42CC 2 Cycle Chainsaw, 18"
...end or the other is probably broken. Both ends need to be attacked and then you set the sprocket or pulley back into the casing. Before you do, you spool most of your rope back onto the sprocket or ...
How to repalce start pulley on Poulin chain saw? First of all the fan housing needs to be removed. No need to remove handle from cord. Just undo screws from fan housing and remove the whole assembly. ...
Question about Pro " Pro" Self Propelled Mower
It keeps eating drive belts! It looks like the pulleys are not parallel. Can you align them? It appears to be spring loaded Either the belt you are using is not the correct lenght and width, or one of
...with the starter removed, pull the cord out, tuck the cord into the cut a way in the side of the pulley and allow the cord to wind in slowley to let the tention off the spring, make sure all the ...
...better to pay somebody else to do it. That said, remove the starter cover with the cord and pulley inside. If there is a plate holding down the cord pulley, remove it and carefully lift out ...
Question about 38-Inch Steel Deck 15.5 HP Briggs & Stratton I/C Engine With 5 Speed
routing mower belt for blades on a poulan ridding #po1538d Bring the belt back from the engine pulley, the outside of the belt will pass to the insides of the two smaller pulleys at the front and head
Question about 17.5HP Lawn Tractor 960120110
...and look under the chassis for the ground drive belt and inspect it. Next it could be loose or bad pulleys. If the transmission input pulley has worked loose or one of the plastic flat idler pulleys ...
Question about 17.5HP Lawn Tractor 960120110
...if it just keep breaking..the most probable cause would be the belt on one the spindle or drive pulley " on engine " is routed around most of the pulley then over the belt keeper instead of on
Question about 17.5HP Lawn Tractor 960120110
On my Poulan Riding Mower model PB14538PB I can only see 1 long belt that goesfrom the engine pulley, around the idler pulleys, and the mandrel pulleys. Where is the 2nd pulley if there are 2? you ...
Question about 17.5HP Lawn Tractor 960120110
...will be, remove the screws securing the starter cover, this will give you access to the starter pulley, turn the pulley manually in the direction of of the engine rotation, can you feel the
Usually answered in minutes!
583 Questions
457 Questions
255 Questions