Questions & Answers for: pull rear wheel bearing 97

97 dakota loud noise from tires while driving Im not sure whats wrong. I replaced the inner tie rod ends about 2 months ago, im sure i need an alignment as well. But the tires howl and the ride is ...

...rear tires are off the floor,then put one hand at 12 o'clock and the other at 6 o'clock on the tire. push with one hand and pull with the other.if you have alot of play in the wheel then it is your ...

...pull the wheel off, drop the caliper, and you'll see three bolts holding the assembly. Take the nut off the end of the axle shaft and be prepared to beat the old assembly off with a heavy hammer. You ...

wheel bearing, the bearing that is bad will be on the side of the direction you steer that lessens the noise. This sounds like a bad hub bearing .It will come as a unit. bearing and hub together .most

...for a 2003 dodge dakota front wheel bearings? 2 wheel drive rear antilock brakes 3.9 Below is a chart from the Dodge service manual. The correct torque for the front wheel bearing is 163Nm or 120ft ...

bad rear wheel bearing on 98 dodge dakota 2wheel drive change the bearing

...rear wheel now play in steer My 97 Geo metro is making slight noise from rear wheel like a flat and now the steering has a lot of play what is it? Thanks Roxy Have the rear wheel bearing checked and ...

...rear brake drums, remove the center grease cup and loosen the axle spindle nut using an axle nut socket. After raising and removing the wheel/tire assembly, finish removing the axle nut and washer. ...

rear axle by pulling off the differential cover. Then remove the bolt holding the spider gear cross shaft in place. Remove the shaft and spider gears. If your tire is already removed and brake drum is

rear wheel bearing in a 97 integra Undo the brake caliper remove the big nut and pin that holds the disc on ,then slide the disc off the axle and remove bearings and seal ,knock out the old cup,s with