Questions & Answers for: how to pull element

...removed, and then pull the broil element out. Remember to turn off power to the range before replacing any of the elements. what are the meanings of gas marks,what is suitable for making ...

...Pull the two screws out of the element (on the back wall) Turn the power off to the oven and then pull the two terminals off the element. Then check the ohms on the element. If no ohms change the ...

...element,you nead to pull them off,the other two wires are hooked to the high limit switch,you nead to pull them off,next there are two 1/4"screws,one on each side off the heating element,remove ...

...inside wall pull element out slowly and disconnect wires,pull off if wire disconnects while pulling element out you'll need to remove rear panel to reconnect hope this helps,please rate my solution

...holding the element to the back wall of the oven, then pull the element out (may have to tug it a bit to get the connectors through the insulation), and pull the wire connector clips off the

...pull the element out. Do this slowly and carefully so as not to have the wires be pulled from the connection pins on the element. If that happens you will have to fish the wire out or pull the oven ...

...to pull the element forward and then the element should have male and female connectors on it that should just pull off, but hold 1 end of wire and the element connector so the wire doesn't fall

...pull the element toward you - it'll come easily, bring its wiring behind it (this is why there must be NO power to the stove!). Detach the wiring from the element... DO NOT allow the wires to pull ...

...pull the element out far enough. Sometimes, the wires pull loose from the element. In either case, you would then have to pull your range out from the wall, and remove the back so you can get to the ...

...pull the element forward. The contacts have enough wire you can pull the element forward to undo the electrical contacts. Make sure the power is OFF! See the videos. ...