projector the bulb lights like it should but only stays lit for around 20 seconds then goes out and the red bulb light lites up indicating a problem with the bulb. We replaced the bulb and it does the
Question about PJ400 Multimedia Projector
...bulb you have installed in the projector might be the original bulb that came with the projecoter when it was new. Just becuase it states 334 hours does not mean it is new. In fact, you could have a ...
Question about LP120 / 1000 Lumens / XGA / DLP Projector Refurbished Multimedia Projector
...bulb into projector - same results Have also seen a slight bit of image "jumpiness" before unit powers down. Color wheel appears to have no problems/cracks Ideas? either the colorwheel motor is not ...
...bulb on my sharp xv-z2000 projector. i replaced it fine but the power light and the bulb light both stay red and i cant even turn the projector on. how do you reset the projector? Two red lights ...
...projector is not working and all the indicators ie, Temp, Power and Lamp are on. I have changed the lamp though and it worked for a while then the lights came on and would not come on. you need to ...
Question about XR-11XC DLP Projector
...bulb just won't stay lit. The problem is: Bulbs wear out. Especially projector bulbs. The operate at high temperature and the filaments break down in time. When they are intermittent (on/off) the ...
Question about EP719 XGA DLP PROJECTOR 2000L 2500:1 CONT DVI-D WITH HDCP Multimedia Projector
...bulb. Hung the projector up and plugged it into the wall and POP. A popping sound came from the projector and popped my GFI. I tried to install Replaced the old bulb with a brand new bulb. Hung the ...
Question about VT58 LCD Projector
...projector parts: lamp, bulb, Lcd panel, Lens, DMD chip, motherboard, powersupply ... with high quality and competitive price. Jerry China Lampdeng Limited Tel: +86 131788 67858 E-mail: ...
Question about Digital Projector Vp6110 Multimedia Projector
...turn off with the bulb light flashing? Bulb has gone bad, and will require a new one. Or check all the fans of the projector and make sure all are running accordingly and nothing is hindering
Question about VP6121 DLP Projector- XGA 2000 Lumens 2000:1
...the bulb is not turning on. Any idea what I could try? The ballast board controls the bulb. It is the board with the wires going to the bulb socket. Replace that and you'll have a working
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions