Question about 1997 Grand Voyager
...Grand Voyager engine won't idle revs stay at 2200 - 3000 rpm Recently change plugs coil and leads, engine revs remain high after starting Possibly the oxygen sensor. Had same problem with my Accord, ...
Voyager transmission problem My 1999 plymouth voyager (3.3l) won't go into Drive, 1st, or 2nd gear. It will only go into reverse. I had the same problem in my 1999 plymouth voyager. Changed both speed
grand voyager is not running right now,it is now making a tapping noise,do i need a new engine and how much will it cost When you say "tapping noise" it names off several problems, please clarify :) -
...grand voyager van The fans under the hood will not kick on, we have checked the fuses and put in a new fan. You either have a bad relay, bad temp sensor, or bad PCM. I would start with the relay as ...
Question about 1996 Grand Voyager
Grand Voyager, hesitation & stalling. I have a 1996 Plym. Grand Voyager, it has a hesitation on acceleration and has started to stall cold & hot. Seems to run okay at highway speeds but starts
...Grand Voyager SE The blower motor 1996 Ply Grand Voyager SE The blower motor started working intermittently and now doesn't work at all. The fan is good, the 40 amp fuse in the power distribution box ...
...problems starting. Rapid ticking/clicking noise when ignition switch turned. Van will start occasionally if i hold switch on till it starts to rev. Other times nothing happens. Very inconsistent. ...
where is the reset switch on a 2000 chrysler grand voyager there isnt a reset switch on it, pehaps a little more info will shed some light on your problem After reconnecting battery it will not start
...Grand Voyager and it ran good for about 50 miles then it cut off and now won't start. it trys to start and battery seems good. Have you checked the fuel filter? It may not be getting fuel. Had an ...
Question about 1998 Grand Voyager
...grand voyager clicks once but wont start. has done in past but usually after a few turns the motor starts again Hi Chris, Try cleaning the battery terminal. You may need to remove them and clean ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions