Questions & Answers for: printer cuts top inch documents

top of the words, scroll down gap (about half inch) then it prints the bottom half of words. other times it prints another sentence over the same line. try to do a system restore to a date when it was

Printer cuts off top 1 inch of PDF document The top content on all my PDF documents gets cut off while printing. The top and bottom margins in my PDF documents are roughly 0.75 - 1 inches; yet the ...

...top and about 1/8" of the document gets cut. printer does not pull in a new sheet so i guess it assumes the whole document was printed. Hi - have you checked the settings for both the document(s) you ...

...cuts off the sheet too early at 4-6 feet this occurs in ?freehand and Illustrator?- It also happens in ?Photoshop and Acrobat on occasion? they are running Mac 10.4.8 software- no updates in the last ...

Top of words are cut off Printer works good and creates a great document except for a couple of words that the top of the letters are cut off. Any suggestions as to what could cause this and how to ...

...top, cutting it off at the bottom. It seems to only do this when the text is double spaced. I tried to reopen and print again, but had the same problems. Have you used page setup in words? is it a ...

...cuts off the top 1/2 inch of the page when printing . Hi Make sure the papersize dial is set for the correct papersize in the copier tray.This dial is the lever you change the papersizes to tell the ...

...top and bottom and 1.25 on left and right but when I go to print, it leaves about four inches at the bottom of the page and 3 on the right. I'm using a Mac and have not had this problem before with ...

...inch top margin and the rest of the image is lost. Is it ok when you just put the document on the glass? If so, the Document feeder needs a whole set of rollers. Otherwise the document scanner may be ...

...top margin of about 3 inch is cut off. Get same problem when i print status report. I don't know that machine but generically, the description suggests a faulty drum or fuser unit... How many prints ...