Questions & Answers for: prime chock start

Engine won't keep running when using the throtle. The motor will start after priming and chocking but when I squeeze the throttle is just dies down. I have fresh oil mix using Mantis oil have cleaned ...

...Prime bulb(4) times, full chock ,pull cord till first stutter sound(start) cut chock down and pull cord till start..Do NOT I repeat Do NOT Touch Gas Trigger at all or it will never start.Should start ...

...chock the run prime it 7 times on the primer ball with the full choke on the pull crank cable 3 times then move choke to half choke then pull until it starts if after 10 pulls it doest start out back ...

prime with fuel direct into the cylinder by removing the plug to get it started. It will then run at full throttle. If I let off the throttle it dies. If it is hot it will restart by just chocking. It

i have to prime nearly every time before it will start check fuel tap filter isnt chocked,fuel pipes clean,float needles not sticking

...start to go dead then work the chocke but do not countiue prime the cabuerator bcuz u will flood it out if u cant get it to work still check ur spark plug to see if it has filed out if so replace

pulls. i use high noctane gas. i prime it at least 7 times as per the instructions i ve had the same problem all i did was take the filter off and open the chock to give it air and it starts everytime

...Prime unit 6 times. Place saw firmly on floor, slide right foot under handle and have left hand firmly on top handle. Pull throttle and lock it in high. Pull rope 4 to 5 times until unit pops.Then, ...

...chock". Back fire means a too rich fuel condition exist in the intake phem of the motor and the fuel /air mixture is back burning through the intake system and is commonly mis understood as flame ...

Starts up when choked then dies. Has a new carb and using 4 cycle fuel that is fresh. Ran great till 3 weeks ago then this. I just went through the same problem with my Yardworks trimmer that is ...