Question about PowerStar AE125 AE125 Whole House Electric Tankless Water Heater...
...water heater. While taking a shower the tank flashes an error code of A3 and E3. Of course the water immediately goes cold. Getting in and out of the shower to reset several times is not fun. Any ...
Question about PowerStar AE125 AE125 Whole House Electric Tankless Water Heater...
water heater. DO NOT BUY A SETS HOT WATER HEATER. We sent it back three times and it never worked. The company was horrible to work with as was its water heater. The Bosch technical service is not bad
Question about PowerStar AE125 AE125 Whole House Electric Tankless Water Heater...
...Powerstar AE125 where the left cut-out trips. This problem began at the end of last winter to the point I was resetting multiple times a week. During the entire summer I might have had to reset the ...
Question about PowerStar AE115 Tankless Water Heater...
Powerstar AE115. Neon light off - Water not hot. Checked everything on the BOSCH troubleshooting pages. Thermal cutouts not tripped and reading 0.4 ohms. Resistance from probes on elements all well ...
Question about PowerStar AE125 AE125 Whole House Electric Tankless Water Heater...
...does not kick on when you turn water on Control unit or flow transducer. If the transducer(impeller in the clear tube) is spinning freely with waterflow, then the circuit board needs to be
Question about PowerStar AE125 AE125 Whole House Electric Tankless Water Heater...
power lite flickers onwater heater when drawing hot water Light flashing while water is flowing means you have a bad control board. Needs to be replaced. They can be purchased online
Question about PowerStar AE115 Tankless Water Heater...
water is cold and the light keeps flashing need to troubleshoot it Light flashing while water is flowing means you have a bad control board. Needs to be replaced. They can be purchased online
Question about PowerStar AE125 AE125 Whole House Electric Tankless Water Heater...
...i reset the breaker it will work? any ideas/ Flashing light means bad control unit..or your flow is too low. If you have a couple fixtures on, and its still blinking, the board needs to be
Usually answered in minutes!
335 Questions
282 Questions
267 Questions
250 Questions
267 Questions