Questions & Answers for: Lexmark no power to my

printer will not power on Try these out: 1. Check for any physical defects on the power cord. Plug printer straight to the power outlet in the wall without using any extensions or power strips. 2. ...

I put a new black printer cartridge in and now it doesn't power up at all. I replaced the printer cartridge with the old printer cartridge and it still isn't powering up. I replaced the power cord, ...

i have a new printer and it has no power Plug the printer straight to the wall power outlet, bypass any surge device or power strips. If still no power. Unplug the power adapter from the printer. The ...

printer is dead was working fine, now there is no power. Unplug the power adapter from the printer. The power adapter is the black box behind the printer where the power cord is attached. Leave the ...

Power will not come on. OUtlet is good. Unplug then replug power adapter from the printer. The power adapter is the black rectangular box behind the printer where the power cord is attached. Make sure

Lost power to printer. Have power up to printer. Unpluged power cord from printer, unpluged power cord from power source.Cannot power up the printer This article in the Lexmark website will help you ...

...printing and the printer shut off after the last page printed and will not turn back on; also the power pack has power Try to unplug the power adapter from the printer. Unplug the power cord from ...

x5470 constantly is powering on and off Please try the steps below:Re-brick your printer. Pull out the power supply, black box where the power cord is plugged in at the back of the printer.Disconnect ...

x7170 not powering up all we see on the screen is a series of bars...we lost power over the weekend and it doesn't seem to be powering up although there is actually power coming from the extension

No power to LexMark x6650 Power cord shows green light but unit won't power up If you are encountering power problems with your printer, please go through the following checklist: Make sure ...