Questions & Answers for: polaris pb4 60 booster pump

...polaris booster pump (PB4-60) and installed it...the polaris ran for a few seconds and shut off. Have you checked for voltage at the pump motor? Did you wire it correctly? Is the motor 110V or 220V. ...

polaris 280 booster pump runs for 30 seconds then trips the safety switch. motor overheating replace pump

Need to replace bearings and seal in Polaris booster pump, pb4-60. Any idea where I can find instructions on how to do this? Thanks! Jim replace whole pump more economical most times

New polaris pb4-60 booster pump shuts off when polaris recycles, why? Runs for about 3 minutes, shuts down, then starts again. sounds like weak motor the back pressure is overheating the motor replace

...polaris pb4-60 booster pump? I have a practically new polaris pb4-60 booster pump. After installing about a year ago it has run fine. A few weeks ago I found a dead rabbit wedged under the ground ...

...pb4 polaris booster pump that doesn't seem to put out enough pressure to run the pool sweep. I have a pb4 polaris booster pump that doesn't seem to put out enough pressure to run the pool ...

PB4-60 Overheating After replacing old motor, replaced outlet, timer, whip, new motor overheats. Reconfigured for 115 volts, same system as old motor. New one runs for 5-10 minutes and shuts down ...

Polaris Booster Pump Brand New keeps shutting off We bought a brand new booster pump pb4-60 last summer and it kept shutting off so we had all of our electral wiring checked and the company replaced ...

...Polaris PB4 - 60, impeller and all seals. When assembling I hand tightened the impeller in place. After running water through it for 10 minutes I turned on the Polaris PB4 - 60. The impeller screws ...