...on button at the top wont work contact point problem. the rubber on your power button cannot reach its contact point due to corrosion and dust. have it checked and have your contact point
...hardened ink You can also clean the contact point on the printer itself. Let the alcohol dries up, reinstall the cartridge then power on again. If error persist, buy new cartridges. Good luck ...
...contact point, put the shifting gear to 1st gear, look at the cam inside the distributor, the highest point of the cam should be touching the contact point slider. Adjust the contact point to about ...
Question about PSC 1410 All-In-One InkJet Printer
...contact point resistance developed. To make it work use a pencil eraser to clean the contact points which should look like golden point contacts. You can use a special polish paper also, which ...
Question about PSC 1410 All-In-One InkJet Printer
...bought a Digipower model TC-U450 and am trying to charge a Nikon EN-EL20. My battery has 4 contact points but there are only 2 prongs on the charger. How do I charge my battery with this charger?
Question about PSC 1410 All-In-One InkJet Printer
...your contact points and your condenser did you replace the coil? Possible wired backwards. Or points are not opening on the other three intervals. only opening on the highest point of
How to insert the battery? take off the back cover of the phone. look at the battery and look for the metal contacts points . Match the contact points with the contact points of the phone and insert.
contact points What's your question? Relays and some fuel pumps have contact points and very old car radios use a vibrating mechanism with contact points. Older ignition systems use contact breaker ...
Question about PSC 1410 All-In-One InkJet Printer
...holding the contact points to the base plate disconnect any wires to the points replace is opposite procedures set the points contact rubbing block on the point of the cam and adjust to correct ...
Question about PSC 1410 All-In-One InkJet Printer
be good enough. Consistancy of point contact closure due to dirty or worn points is the biggest problem. New point contacts should be cleaned with alcohol to remove oils accumulsted during manufacture
Usually answered in minutes!
8,663 Questions
6,597 Questions
5,420 Questions
5,130 Questions
4,425 Questions