Questions & Answers for: platter drag

...platter drag I just bought a used SL-1200MK2 off of E-bay and had it shipped to me. I was told that the unit worked just fine before shipping, and it was very well packaged in bubble wrap surrounded ...

...platter becomes offset and shudders causing the styli to drag across the hole track ;.( Problem is with the center shaft/spindle. Part can be replace, but not tightened. This happens over time. You ...

numark cdx when i press the start button the platter slowly drags until it builds up to speed. If i turn the motor off for the platter, the music starts fine. have you checked the brake and start up ...

...Betsy HELLO BETSY! It's pretty easy to change a belt on a turntable. Lift off the rubber mat and platter (the round part that turns) and you will see the motor on the deck. The platter has a rim ...

...hasn't been dropped or damaged in any way. You will need to check your belt for wear. Lift felt on platter and check belt tension. It may need replacing. To replace, simply lift platter section of ...

Bang and Olufsen - Beogram RX 2 turntable. Platter is out of level, album rubs on base frame and drags. Just tried twice with a ''professional'' repair service to correct - no luck. Same problem. Did ...

Stiff Platter How do I loosen up the platter? It seems to be getting stiff on me? If the platter gets tipped, it MAY be dragging the case underneath. If it is tipping, investigate why that is ...

Just setting up my Crosley and turntable is lop-sided to the point its dragging on the right side Sometimes there are transit screws that have to be unscrewed so that the platter can float easily.

record As you said, it's dragging. First off, check the belt to make sure it is not slipping on the platter or the motor pulley. If it's not, I would have to say that the spindle pulley is freezing up

...drag as the record plays. Remove the felt cover on the turntable then remove the platter the records sit on. It should pull up and off. Over time the platter settles in place so it might not want to ...