Questions & Answers for: plastic studs

...but you should be able to get back in i'm guessing by the picture it's a husvarna,does it have a plastic or metal oil tank??????the differance is plastic,studs are molded together,metal they screw

studs too far apart. It appears that the plastic door side supports have spread apart, and the tray studs are too short? Any suggestions? Are stud extensions available? Hi there. Take one of the trays

...plastic studs from door closer. Unscrew three retaining screws. remove grab. Unhook window winder retaining clip. Best done with small long-nose pliers. window winder retaining clip located inside ...

They are not really replaceable, just find some self tapping scews and replace the plastic studs with these... it wont look like it did but if you get some smart looking screws it could look better..

...plastic studs to hold in the panel. Start at the bottom and pull out using a thin screw driver as a tool. once you break the plastic stud you will see how it is held in place. They do break and those ...

...off or broken. I would look up under the cowl to see if everything is intact. there is a little plastic bushing that keeps the arm to the motor its more than likely worn out the arm should have a ...

...plastic studs that the metal guide on the drop side rail slides over are missing (headboard and footboard). How can I get these parts? I have a similar problem with one of my plastic studs. My ...

how do i replace stud bolts that tighten the bar if this is the plastic crankcase machine, the bar bolts are pressed into the case, start by removing the muffler, use a punch and drive the broken stud

...plastic 'studs' about 1/4 of an inch located at both ends and center (F5 and F9) of the plastic strip just above the keypad. Underneath these 4 plastic studs are 4 small screws. Above all, don't be ...

...thread (assuming course was old thread) with a die and used std fine nuts on them as well . if studs go in plastic case/frame then case needs to be disassembled and then studs press out other ...