Questions & Answers for: Dodge plastic grill

...grill panels. Remove the screws from the upper two panels. The panels have a plastic rivet at the very top which can't be removed unless the hood is open so bend the panels up to gain access. With a ...

...bar for the front bumper. Look at the front of the Vehicle and it's on the right remove left plastic wheel sheild and the horn is just ahead of the tire on the front core support by the ...

...battery. Then remove both windshield wiper arms (by using a small screw driver and prying up on the plastic cap); mark the location for the wiper arm and remove the nut from the center of arm. Then ...

...a headlight lamp 2009 dodge ram Disconnect and isolate the battery negative cable. Remove the four plastic push-in fasteners that secure the upper radiator seal to the grille support and both fender ...

...remove plastic grill screws2 then 1 screw on outside corner of headlight housing and open hood there is one long screw that needs removed then the headlight assy will almost fall off the

Broken plastic grill on a 1999 Dodge Dakota Can I replace the plastic grill on a Dodge Dakota You can do that. The best bet is to see if a body shop can order it for you.

...grilleOn RAM, remove the four screws that hold the grille.On Dakota and Durango, remove the four plastic nuts along the length of the grille, and the plastic rivets and push-in retainers at the ...

...for is to remove the cross member that the hood latch bolts up to. You will have to remove a few plastic clips that retain the grille to that part but you should not have to remove any major body ...

...middle of the radiator, either in the front or rear side of the corners. It may be covered by a plastic air dam or under-engine fascia panel that may need to be removed to access the drain plug. ...

...plastic surround from the center console and remove the screw next to the grill adjacent the door (driver's side). Once the screws are removed, the hard plastic piece just pops out. (Remember, to ...