Questions & Answers for: pitch diameter Cars & Trucks

pitch. Is this the case? I also need to know if the stem diameter of collets is somewhat like 4.3mm with the length being about 15mm. Is this also the case? Thanks a lot in advance for answers. metric

...of the outer tie rod threads & the thread pitch of the threads If it appears to be a metric size,the thread pitch will confirm that & you convert the diameter to metric by dividing by ...

...never said) then use a pitch guage. $1 tool. then the diameter ,yes, use a $1 mm rule. and read it. now you have pitch and diameter, that leaves lenght and id bet you can do that easy now. (the

...diameter & thread pitch? You will have to mic the diameter & convert to metric or just match up at a store As a guess only--dia may be 1/2 "or 12mm & length say 2" or 50mm .0395 is (1) mm ...

...diameter and thread size of the wheel lug nuts on a 1997 Lincoln Continental ? 12mm dia x 1.50 thread pitch Pretty much a standard size for most vehicles I found that on RockAuto.Com You need to make ...

...diameter, metric, 8 or 10mm and pitch so using a box of random bolts with starter off find one that fits, m8 or m10, or m12. now you know the sizes, and with starter off the holes are right there. in ...

...rims fit on Mazda tribute only if the pitch circle diameter for the studs is the same and the off set is correct who makes the rims is immaterial it is the stud pattern and the off set that ...

Will 5 stud hilux rims go on a Mazda tribute try the spare on one and see I doubt it as the pitch circular diameter of the studs are most likely different

is the size and thread of a Mazda rustler 2000 model rear stub shaft The rear stub shaft on a Mazda Rustler 2000 model has a diameter of approximately 1.22 inches (31 mm) and a thread pitch of M20x1.5

...diameter is found easy as pie is pitch lay the old tread against the new and they mesh perfectly or like me own a $1 pitch tool. and calipers and measure mm all day long. or buy them from Ford ...