Questions & Answers for: pitch diameter

Ad

...pitch you can then match up the tap diameter to the plug diameter. Chances are the dealer's parts manual will have the sizes showing along side the image and part number. I would get a new plug ...

Ad

Question about 2006 XL 883L Sportster

1 Answer

...of a caliper bridge bolt for a 2006 883 sportster All American threads are the same bar diameter and pitch. measure bolt diameter and count number of threads per inch, use HT steel and plated;

Ad

Question about 2006 XL 883L Sportster

1 Answer

...pitch. If you can measure the diameter of the threaded shaft, you will find that the actual diameter of the threaded part is just a little smaller than the nominal size. For instance, a 5/8 diameter ...

Question about 2006 XL 883L Sportster

1 Answer

spur gears need to find the pitch, if the pitch diameter is=12.3875 and the number of teeth is 40 whats the outside diameter of the gear?

Question about 2006 XL 883L Sportster

1 Answer

pitch. Is this the case? I also need to know if the stem diameter of collets is somewhat like 4.3mm with the length being about 15mm. Is this also the case? Thanks a lot in advance for answers. metric

Question about 2006 XL 883L Sportster

1 Answer

...of the outer tie rod threads & the thread pitch of the threads If it appears to be a metric size,the thread pitch will confirm that & you convert the diameter to metric by dividing by ...

Question about 1999 Trooper

1 Answer

...never said) then use a pitch guage. $1 tool. then the diameter ,yes, use a $1 mm rule. and read it. now you have pitch and diameter, that leaves lenght and id bet you can do that easy now. (the

Question about Band Saw Misc. Nuts, Bolts And Hardware

1 Answer

pitch diameter of .2500-28-unf-2b bolt? Why would you need the pitch diameter? Almost no one needs that data. Have you googled it? Just google ".25-28 unf 2b pitch diameter". I found it to be .2311 on

...pitch you will get better hole shot out of the water ,but my be lose a little top end speed. This will be stamped or cast into the prop eg: 15x21 which stands for 15 inch diameter by 21 inches

...diameter by 1/2" on the four blade will help top end, and then try increasing the pitch to maybe a 22 if hole shot is still good and top end lacks. You could also add trim tabs if you don't have them ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5968 Answers

Marvin
Marvin

Level 3 Expert

85216 Answers

richard libby

Level 2 Expert

209 Answers

Are you a Motorcycles Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...