...block and put new piston with new rings. the ather thing it hapen sometimes when you fitting piston rings, check how piston rings is it should be all piston rings defrent direction inside the piston ...
piston with a clamp. The block has several different pins with different shapes. Find the one that fits into the piston, put a 3/8" ratchet in the center of the block and then turn it clockwise (right
...block taking care to ensure that the piston is at the top of the cylinder so that the big end doesn't damage the crank journal as you slide the cylinder down into the block I take it that the engine ...
Question about 2000 Tucson
what will be the problem if i found water on the top of the pistons If there is water on top of pistons then you have a leaking hard gasket one fix is drain all coolant out and fill with block sealer ...
...block or piston to maintain compression. When the water pump goes out then the engine overheats and the rings soften and break scoring the cylinder walls . In really bad cases the rings may seize and ...
Question about 2000 Tucson
...block. PISTON & CONNECTING ROD Remove connecting rod bearing cap retaining nuts and bolts, then separate bearing cap from connecting rod. Using the wooden handle end of a hammer, push the piston ...
Question about 2000 Tucson
...piston fitter, does his magic. the 4.0 block is stamped, but 5.9L not sure. but you can look on the block decks to find that, easy. ...
...block and piston The figure you are asking for isn't generally included in the data and much depends on the engine design and the sort of work you are carrying out. Mostly the specs for the block and ...
Question about 2007 Navara 2.5
I have replaced Bearings,pistons and rings on my 2,o Gsi and find after they skimmed the block that my pistons protrude above the block by about 15thou.Is this acceptable Not likely! Pistons will need
Question about 2007 Navara 2.5
...piston rings, it is rather common to replace many other parts at that time. Commonly, all of the replaceable bearings ( crank & cam) are changed. Also commonly, the engine block is bored so that ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions