Rear bumper on Ford fusion Should my 2008 Fusion rear bumper have push pins under the bottom to keep from flapping?? Are there holes for them? Then yes, if not then no.
...trapped disc.(It still plays but won't eject) Not sure of the manufacturer - but most have a small pin hole near the CD insert slot - inserting a straightened paper clip into that hole a few times ...
...put from the computer to the obd ll port if good need to check the wiring harness ,connections and pin contacts from computer to obd ll port connections possible short,frayed or broken ...
I have a 07 fusion factory installed remote starter it beeps locks the doors then beeps twice but don't start. My under standing is something is open but I checked the doors and the hood pins. Any ...
ford fusion wireing diagram. the sjb. just need to know the connector letters and pin numbers here ya go
My 2006 Ford Fusion has issues. When driving, if you take your foot off the accelerator, it jerks so bad and slows down...I mean JERKS... as it slows down, then when you want to accelerate again, it ...
fusion rolls in park Only one thing can cause this, the pin that locks the transmission when shifted to park position is broken/sheared off, the bottom pan of the transmission must be removed and the ...
Question about 2004 Fusion
clutch pedal on ford fusion 3 goes down pin or something comes out My clutch pedal kept slipping off the rod. I attached a washer with screw tightner to the rod. The pedal nows stays put and does not ...
Question about 2008 Fusion 3.0
...that doesn't help.so I took the cover off and I noticed a device in a shape of a C battery with a pin that moves in and out.also its connected to a plastic piece and when I move the plastic piece ...
...I remove the headrest from 2007 ford fusion? a standard ford head rest look for a pusher button or pin on the base plastic where the two metal guides go into the top of the seat might need to to
Usually answered in minutes!
750 Questions
244 Questions
135 Questions
91 Questions
53 Questions