ETX90 power supply Can someone tell me which the centre pin of the 12v adapter should be... + or - Also does anyone know if the telescope draws more than 15-00ma. Thanks The center pin is positive & ...
Question about LXD55 Telescope
Replace connector on wire from DEC drive Motor on a LXD55 telesco The 8 PIN Connector on the end of the wire from the DEC drive motor on a meade LXD55 telescope was cut off. Does anyone know the wire ...
...new batteries does not fix this, also try looking at the cable ends to make sure none of the small pins are bent. If all of the above is OK-- this error usually indicates a fatal error in the ...
...my problem : My scope model is LX200R 14?. I?ve pulled the focuser shaft out of the focuser arm pin. I?ve turned the locking lock knob several turns before putting back the focuser shaft. I ...
...of the 6 foot with the unit. I am using a good ethernet cat 5 cable with an extension coupler, same pin out 1 goes to 1 , ohm this out all seems fine, but the controller doesn't respond, wants be to ...
Question about 494 AutoStar Telescope Control Unit (Handbox only)
message...Proc. trap 2 what does it mean ? It means the firmware is corrupted. It may be possible to reset it from software. Try and reload the Autostar firmware from a PC. (Download the updater ...
...my Autostar Suite and a computer. I have the USB to RS 232 cable and the connector to go from the 6-pin connector to the RS232. I get everything connected, configure the com port correctly and try to ...
Question about 114EQDH4 (36 x 114mm) Telescope
...power says 15 volts Mant thanks Yes you can just make sure that the power cord has the CORRECT pin polarity- you can order the 12 volt cigarette lighter style cord from Meade. ...
...LX200GPS I have a 14" LX200GPS and I think the primary mirror lock malfunctioned as it just spins in both directions with little resistance. I think I unscrewed it to far and now I can't ...
Question about LX200GPS 14" (850 x 356mm) Telescope
What IC's uses the control of the focus motors The IC's that control the focus motors are burned, I need to know the part number of the IC's and the board's schematic I'm assuming you will change ...
Usually answered in minutes!
106 Questions
88 Questions
68 Questions
50 Questions
43 Questions