Questions & Answers for: phone reads line

...reads, "Auto receive". When attempting to fax, the busy light flashes. Busy light stops flashing for 30 seconds, then starts flashing again. Above is the default settings for the fax. NGB0 indicates ...

seperate phone units. Have unpluged/unpluged phone lines from wall phone outlets. Still same problem. We followed your instructions and are not sure what worked, however, this AM phone line is working

phone line I have trouble faxing over my digital phone line, I have CallVantage with AT&T. Seems the machine feeds all papers, but only "sends" the 1st sheet...ends up with an error report. Any advice

...phone reads Error we have three phone line but only one phone cord that's connected to our current phone system, but we are upgrading to the RCA. there's only one problem, the RCA has two separate ...

...phone line went out. When fixed the cordless phones read "no line." I have tried unplugging them and then after 10 minutes replugging them to no avail. I disconnected all cordless devises ...

...phone set reads parallel phone is on and it is not on. I have unplugged the phones and did all that is required and it still reads the same Check the voltage between your incoming phone lines. It ...

...reads "no line." Thoughts? I had the same message. After a length investigation, I found it was the phone line and not the phone. After having the phone line fixed, the phone worked

...phone reads "forwarded Deborah" & I have done the *73 but it still reads that. Please help! Thank you Deborah Foreman press the call forward key on the set that is forwarded. if no ...

...phone. if say using AT&T, land line (wild wild guess) you have special *Number to call and you must reset that using THAT> answered for both ways, and I refuse to read your manual, on any ...

Phone line is "busy". When I select the the line it reads: 701:BUSY CBK. How do I force the system to either disconnect the call or pick it up so I can hang up? Thank you, The phone system is a ...