Questions & Answers for: Sharp Aquos philips 42 flat screen flashing

...42 while watching tv my television turned itself off and now both the power and opc lights are flashing. TV willnot turn on You either have broken power board or main board. Power board - blinking 2 ...

...red lights flash on the remote through the screen, if you see it , then your main board in the tv isnt reading it, if you dont see it flash, there is a problem with that button on the remote, there ...

42 LCD power light is flashing/no picture. Any ideas? Your interface signal processor has a problem, or power supply circuit is defective. The tv needs to opened and serviced. If you would like, I can

...screen. Commonly called a Backlight Inverter Board. I can't say it's 100% the problem because I can't actually look at the tv over the internet. If by chance the TV is still under warranty, go that ...

...42 in LCD TV - POWER LIGHT IS FLASHING RED, REMOTE WILL NOT TURN IT ON OR OFF. The side power button turns it on and then it turns its self of in a couple of sections and you don't see anything on ...

power LED light stable?Few sec.Power LED and LED OPC flashes?This very common on Sharp tv,tries power off/on at 4 or 5 each time it flashes,well power up have backlight on and it work.After this doesn

...42 inch 42d62u does not come on. When I unplug it and plug it back in, the power light and OPC light is green and will flash twice simutaneously then the OPC will flash once. It keeps doing this no ...

...42-D62U won't power up. The power light blinks twice, then the power light and the OPC light blink together once. any fix to this problem? Ur Tuner signal board have problems or dead.Ur power LED ...

...red? the tv wont power up. can u help? dear user, supply capacitor are weak.kindly change the capacitors The flashing light is caused by a protect circuit. You need to count the flashes to help solve ...

...screen comes up briefly, then goes off, with flashing red light. LCD TV Sharp LC-42DH77E model any help very much appreciated? Sounds like a power supply problem - take off the back check voltages ...