...Peavey 8600 without splitting the watts. How do I hook up monitor speakers in this situation? Can another mixer be patched into the front? I have an XR 400. Sorry, but this unit does NOT support ...
...mixer to it ( i wanna use the peavey as an amp?? That's easily done. Simply connect the left(or right) output of your mixer to one of the channels on the peavey. Use any line input. Since the peavey ...
Question about Xr 8600 8 Channel Powered Mixer
...peavey 8600 powered mixer. If i run powered speakers through the main output on the front will I not have effects? If you run the speakers FROM the main you should have BOTH the effects and the EQ ...
...mixer to a Peavey xr8600 with out going through the 8600's mixer? I am wanting to use the 8600 to power my mains and use another amp to power my monitors. can i do this? You CAN drive the power ...
Question about Xr 8600 8 Channel Powered Mixer
...peavey? My power mixer rolled off my cart and fell less than 2 feet on a floor, causing no external damage on the case. Tried to turn it on and the unit will not power up. The fuse is probably placed ...
Question about Xr 8600 8 Channel Powered Mixer
...peavey 8600. will it run a pair of 600w 4ohm cerwin vegas? Hello, This is the amp capacity, 600W @4 Ohm, so you just have to drive them below full power to avoid excessive distortion, but certainly ...
Question about Xr 8600 8 Channel Powered Mixer
Peavey XR series 600 may have been left on without one speaker plugged in, what is the likely diagnosis? Out put amplifier is defective. If it was protected by a fuse - then look for a fuse that is ...
Question about Xr 8600 8 Channel Powered Mixer
...peavey xr 8600 powered mixer . Not the xr 8600D . THANKS THE SPEAKERS WERE OVERPOWERED AND SHORTED. THE SHORTED SPEAKERS DAMAGED THE AMP.( PEAVEY XR8600 )LOOKING FOR A SERVICE MANUAL . ...
Question about XR 8600D Class D Powered Mixer
front panel of the Peavey Mixer, you would use the 1/4" main output and connect it to the input of the Bose. Since the Peavey is not stereo, you will need Y cable, 1/4" mono phono male to (2) RCA male
Question about Xr 8600 8 Channel Powered Mixer
PEAVEY XR 1600D Powered Mixer Desk, POWER CORD REPAIR. I need the wiring sequence or schematic for the power cord plug end. Colors are Blue Brown and yellow w green stripe That is standard UK wiring. ...
Usually answered in minutes!
297 Questions
192 Questions
155 Questions
161 Questions
136 Questions