Questions & Answers for: pb4 60 motor turn

pb4 booster pump overheats pump is a rebuilt pump and it overheats within in 10 minutes of turning on. ( too hot to lay your hand on and smells hot) Output pressure is also low. Would a restriction in

...pb4 booster pump is leaking from the booster pump bracket and making a ''whining'' noise when turned on???? Replacing the pumps mechanical seal should fix the leak. The whinning may be from bearing ...

...pb4 pol pump buzzes for a few seconds and then stops and doesn't do anything, Check for a jammed impeller in the pump. Otherwise, sounds like the capacitor is probably bad. Either in a raised housing ...

PB4 pool cleaner pump. The pump motor had power but was not turning. I spun the exposed shaft of the motor with my finger and its been running now since yesterday. Is it possible the pump was bound up

pb4-60 booster pump? I have a practically new polaris pb4-60 booster pump. After installing about a year ago it has run fine. A few weeks ago I found a dead rabbit wedged under the ground cable. I don

PB4-60 Overheating After replacing old motor, replaced outlet, timer, whip, new motor overheats. Reconfigured for 115 volts, same system as old motor. New one runs for 5-10 minutes and shuts down ...

Pb4 booster pump is trying to engage. It has a humming noise every 10 to 15 minutes but will not engage turn off try spinning the back shaft of motor then try if still doesn't work need new pump or ...

pump pb4-60will not run if voltage to it and filter pump running see if shaft turns maybe bad capacitor or motor

...PB4 - 60, impeller and all seals. When assembling I hand tightened the impeller in place. After running water through it for 10 minutes I turned on the Polaris PB4 - 60. The impeller screws into to ...