...the top drawer tray out (paper was empty) and left it open. Turned off and unplugged the machine (hard-boot). Pushed the tray in, plugged in and it worked just fine. thanks for this great
...tray). It hasn't managed to lift the paper successfully. Open the tray, remove the paper, reset the machine (open/shut front door) then reload the paper and try again Hope that helps Regards ...
Question about bizhub C351 All-In-One Laser Printer
...paper tray. It should default to tray 1, but is pulling from tray 2. 1) push Utility/counter 2) system settings 3) paper tray setting On the right side you'll see the trays. Highlight the tray and ...
Question about bizhub C250 All-In-One Laser Printer
...paper tray due to poor stacking of the paper in the paper cassette. try another paper tray or check the paper in the paper tray for folded over papers usually near the bottom. Also try feeding paper ...
Question about bizhub C351 All-In-One Laser Printer
...select the #1 paper tray or the #3 paper tray its probly because the tray attributes are off.. check to see if the trays have the exact attribute you are printing... if not then change ...
...position against the edge guide of the universal tray". Nothing we do makes any difference Open and remove the paper tray. Clean the paper sensor inside with a clean cloth. Return the paper
...when i install the Bizhub c220 the machine is showing tray 1 is empty even after loading the paper. pls advice me pull out tray and check any paper is jammed is remaining at the back end of that ...
Question about PRINTING - Bizhub-250 Minolta 25ppm Printer/Copier/Scanner/Fa
...gear.Remove the misfed paper and push in the tray ,open and closed the right door and the copier must be ready. C 0204 - 2nd tray C 0206 - 3 rd tray C 0208 - 4th tray C 0211 - bypass tray Good
Question about bizhub 250 All-In-One Laser Printer
...250 only detects letter when i place an A4 paper, how do i make it detect A4 Clean the paper size sensor and change the by pass paper tray size setting on the display "Paper tray change" setting
Question about Bizhub 600 750 Image Control Board 57aa-9016g
bizhub 600 reads wrong paper size in tray 1 indicates 5.5x 8.5 paper in tray 1 Is tray 2 OK? Any paper stuck behind the draw. Check the setting off draw one in user mode is it for that size paper?
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions